NEC Univerge SV9300 Series - Boss;Secretary Calling

CALL FORWARDING -
BUSY LINE
This feature permits a call to a busy extension to
be routed to a designated terminal.
TO SET CALL FORWARDING -
BUSY LINE
This feature is set by Soft key or feature key.
The
feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
1. Press
the Soft key (>>>>) repeatedly
until display shows “FDN” when
Soft key is used.
MARY SMITH [200]
4:26 PM MON 11 MAY 2015
FDA FDN >>>>
2. Press Soft key (FDN) or Call
Forwarding - Busy Line feature key
.
Forward to : _
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
3. Dial the desired target terminal
number
.
SET 201
4:26 PM MON 11 MAY 2015
4. After 4 second, return back to the
idle screen automatically
. (or Press
Speaker key)
Speaker key lamp goes off. →
Line key lamp goes off. →
TO VERIFY
1. Press Soft key (FDN) or Call
Forwarding - Busy Line feature key
The terminal number of the forwarding
destination is displayed on the LCD.
TO CANCEL
1. While being set the Call Forwarding
- Busy Line,
2. Press
the Soft key (>>>>) repeatedly
until display shows “FDN” when
Soft key is used.
MARY SMITH [200]
4:26 PM MON 11 MAY 2015
FDA FDN >>>>
3. Press Soft key (FDN) or Call
Forwarding - Busy Line feature key
.
Forward to : 201
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
4. Press .
CANCEL
4:26 PM MON 11 MAY 2015
5. After 4 second, return back to the
idle screen automatically
. (or Press
Speaker key)
Speaker key lamp goes off. →
Line key lamp goes off. →
FEATURE OPERATION
76