2. Press Answer key
.
Answer key lamp goes off. →
Return to original call.
CW 201
4:26 PM MON 11 MAY 2015
MIC CONF Recall
SYSTEM CLOCK SETUP BY
ST
ATION DIALING
This feature enables a terminal user to adjust the
system clock.
The feature access code/feature key is set by
system data setting at initial installation. For
details, please contact the system
administrator
.
1. Press Speaker key
.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial System Clock Setup access
code or press System Clock Setup
feature key
.
You will receive a feature dial tone.
4:26 PM MON 11 MAY 2015
Recall PICK >>>>
3. Dial new time in 24 hr
. format using
6 digits (HHMMSS).
You will receive a service set tone.
110000
4. Press Speaker key
.
Speaker key lamp goes off. →
FEATURE OPERATION
88
To Next Page
Loading...
