STEP CALL
This feature allows the terminal user
, after calling
a busy terminal, to call an idle terminal by simply
dialing an additional digit.
The feature is set by system data setting at
initial installation. For details, please contact
the system administrator
.
1. Lift the handset.
Line key lamp lights green. →
BUSY 201
4:26 PM MON 11 MAY 2015
CB CW >>>>
2. Dial the extension number
.
You will receive a busy tone.
3. Dial the last digit (0-9) of another
terminal.
Example: Dial “2”.
202
4:26 PM MON 11 MAY 2015
MIC Mute
It is possible to select the last digit of the
extension number from 0-9 arbitrarily
.
CALL WAITING
This feature allows a terminal to camp itself on to
a busy terminal.
This feature is available only for the terminal
that is set by system data setting at initial
installation. For details, please contact the
system administrator
.
TO ACTIVATE CALL WAITING
1. Receive a busy tone.
BUSY 201
4:26 PM MON 11 MAY 2015
CB CW >>>>
2. Press T
ransfer key.
3. Press Soft key (CW).
You will receive a special ringback tone.
CW SET 201
4:26 PM MON 11 MAY 2015
Recall VOICE CB >>>>
TO ANSWER CALL WAITING
1. Call in progress.
210
4:26 PM MON 11 MAY 2015
MIC Mute
2. Call Waiting feature is set.
Answer key lamp flashes red. →
You will receive a Call Waiting tone (three
tone bursts).
CALL WAITING 201
4:26 PM MON 11 MAY 2015
MIC Mute
3. Press Answer key
.
The original party is placed on hold and
connected to another party who initiates Call
Waiting feature.
FEATURE OPERATION
74
To Next Page
Loading...
