Netafim NMC-64 - Page 65

100 pages

Save Page as PDF

To Next Page

To Previous Page

User & Installation Maunal Software

• Main Valve – configure a main valve to each misting valve. This setting is not

necessary in case the cooling doesn’t have a main valve.

Main Page

Table of Contents1
- Table of Contents2
Introduction6
- General Description6
- Main Features6
- Operation of the NMC-647
- Hot Screens10
Software17
- Getting Started17
- 1 Program18
- 2 Manual34
3 Alarm36
- Alarm Reset36
- History37
- Alarm Definition37
- Alarm Setting39
4 History40
- Irrigation Log40
- Uncompleted Irrigation41
- Uncompleted Programs42
- Daily Irrigation42
- Irrigation Accumulation43
- Aux Meter Accumulation44
- Accumulation Reset44
- Filters45
- Cooling45
- Sensors Log46
- Event Log47
- System Log47
5 Test48
- Relays48
- Digital Input49
- Analog Input49
- Temperature50
- Humidity50
- Hardware Check List51
6 Setup52
- Time & Date52
- System Setup53
- Temperature Calibration55
- Humidity Calibration55
- Ec/Ph CALIBRATION55
- Weather Station Calibration56
- Sensors Logging56
- Write to Data Plug57
- Read from Data Plug57
- 7 Configuration58
- 8 Installation66
Hardware69
- General Specifications69
- Power Supply69
  - Specifications69
- Dry Contact Output Card71
  - Specifications71
- 24AVC Output Card72
  - Specifications72
- Digital Input Card73
  - Specifications73
- Analog Input Card74
  - Specifications75
Troubleshooting77
- Led's Indication77
- Problems and Trouble Shooting78
- Alarm List80
Appendix81
- Cold Start Procedure81
- Version81
- General Description82
- Functionality82
- Reset82
- Short-Circuit Threshold Level (A/D)82
- Short Circuit Control82
Plug & Play83
Limitation Table85
Priority Specifications86
Electrical Grounding86
- Ground Rods86
- Ground Wire88
- Ground Clamps88
- What Should be Grounded89
- Lightning Protection89
Electrical Connections90
Sensors and Shield Wiring91
Ec/Ph Correction Adjustment92
EC Transmitter & Sensor Connection and Calibration93
- Connecting EC Sensor to Transmitter93
- EC Transmitter Calibration93
- Connecting EC Transmitter to NMC-64 Controller94
Ph Transmitter & Sensor Connection and Calibration96
- Connecting Ph Sensor to Transmitter96
- Ph Transmitter Calibration97
- Connecting Ph Transmitter to NMC-64 Controller97
- Ph Definitions and Calibration99
Netafim Limited Warranty100

Netafim NMC-64 - Page 65

Table of Contents

Related product manuals