NMC-64 Irrigation
Setting an irrigation that is longer than 24H:
An active irrigation will not change when the irrigation is longer than 24 hours there will
be no changes in current sequence according to Cycle Days.
Example 1: If cycle days is 1 and the irrigation length is 30 hours, the irrigation will
repeat itself every 30 hours, so that it will be continues irrigation.
Example 2: In order to perform an irrigation that is longer than 24 hours with stops in
between, the day cycle should be more than 1. In the example above, if irrigation Run
Time is set to 30 hours the program will operate as follows:
1. Fertigate for 30 hours
2. 1 day without irrigation.
3. Irrigate water only for 30 hours.
4. 1 day without irrigation.
5. Fertigate for 30 hours
6. 1 day without irrigation.
1.2 WATER RUN TIME
WATER RUN TIME
Prog. Method Water Before After
1.
2.
3.
4.
5.
QTY. 4.0 0.1 0.5
TIME 1:02:00 0:10:05 0:20:05
QTY. 3.0 0.1 0.5
QTY. 2.0 0.1 0.5
QTY. 4.5 0.1 0.5
Table 1.2 has 60 “floating” programs that can be later connected to a valve or a group
of valves through the Irrigation Program. Irrigation can be set by time (HH:MM:SS) or
quantity (m3 or Gallon), choice per Run Time program. Each program includes water,
water before and water after definitions.
• Method – Select the method with the Up/Down arrow keys and press ENTER to
confirm.
QTY.
TIME
22
To Next Page
Loading...
Need help?
General
