User & Installation Maunal Software
• Water – set Quantity / Time for each program (Liter or gallon). The water setting is
the total quantity / time including the Before and After settings.
• Before – set Quantity / Time without dosing at the begging of each irrigation cycle.
• After – set Quantity / Time without dosing at the end of each irrigation cycle.
Before and After settings are deducted from the Water settings therefore
Water quantity / time must be larger or equal to the Before and After settings.
1.3 DOSING
FERTILIZER PROGRAM
Prog Method -1- -2- -3- -EC- -pH-
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
P.Qty 5.0 3.2 2.4 0.00 0.00
P.TIME 00:10 00:10 00:30 0.00 0.00
TIME 00:10 00:10 00:30 0.00 0.00
QTY 5.0 3.2 2.0 0.00 0.00
P.Qty 0.0 0.0 0.0 0.00 0.00
P.Qty 0.0 0.0 0.0 0.00 0.00
P.Qty 0.0 0.0 0.0 0.00 0.00
P.Qty 0.0 0.0 0.0 0.00 0.00
P.Qty 0.0 0.0 0.0 0.00 0.00
P.Qty 0.0 0.0 0.0 0.00 0.00
The NMC-64 includes 10 predefined dosing programs. Each program can operate
according to one of four methods. Each channel can be set to give a different amount,
overlapping between the various channels is possible.
Dosing programs can later be assigned to a valve or a group of valves in table
1.1
IRRIGATION
• Method – select one of four methods:
1. P.Qty (1/1000) - Proportional quantity. Each dosing channel can be set to to
give a different amount. The set amount is 1 part (Liter or Gallon) fertilizer/Acid
per 1000 parts (m
3
/h or 1000 Gallons) of water.
• For example:
• Channel -1- is set to 5.0 (liters or gallons).
23
To Next Page
Loading...
Need help?
General
