NETGEAR FVS318N

IPv4 Firewall Protection
117
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
on page 118) or Edit LAN WAN Inbound Service screen (identical to Figure 56 on
page 119) displays, containing the data for the selected rule.
 To enable, disable, or delete one or more rules:
1. sele
ct the check box to the left of each rule that you want to enable, disable, or delete,
or click the Select All table button to select all rules.
2. Click one of the following t
able buttons:
• Enable. En
ables the rule or rules. The ! status icon changes from a gray circle to a
green circle, indicating that the selected rule or rules are enabled. (By default, when a
rule is added to the table, it is automatically enabled.)
• Disabl
e. Disables the rule or rules. The ! status icon changes from a green circle to a
gray circle, indicating that the selected rule or rules are disabled.
• Delete. Deletes the sele
cted rule or rules.
LAN WAN Outbound Service Rules
You can define rules that specify exceptions to the default rules. By adding custom rules, you
can block or allow access based on the service or application, source or destination IP
addresses, and time of day. An outbound rule can block or allow traffic between an internal IP
LAN address and any external WAN IP address according to the schedule created in the
Schedule screen.
You can also tailor these rules to your specific needs (see Administrator Tips on page 108).
Note: This feature is for advanced administrators. Incorrect configuration
might cause serious problems.
 To create a new outbound LAN WAN service rule:
1. I
n the LAN WAN Rules screen, click the Add table button under the Outbound Services
table. The Add LAN WAN Outbound Service screen displays: