Virtual Private Networking Using IPv4 IPSec and L2TP Connections
209
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
4. Specify the settings that are explained in the following table.
5. Click App
ly to use the new settings immediately, and click Save to keep the settings for
future use.
6. Click the Advan
ced tab in the Authentication pane. The Advanced pane displays.
Figure 121.
Table 51. VPN client authentication settings (Mode Config)
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the wireless VPN firewall. For example,
enter 192.168.15.175.
Preshared Key Select the Preshared Key radio
button. Enter the pre-shared key that you already
specified on the wireless VPN firewall. For example, enter H8!spsf3#JYK2!. Confirm
the key in the Confirm field.
IKE Encryption Select the 3DES encryption
algorithm from the drop-down list.
Authentication Select the SHA1 authe
ntication algorithm from the drop-down list.
Key Group Select the DH2 (1024) key group from the drop-down list.
Note: On the wireless VPN firewall, this key group
is referred to as
Diffie-Hellman Group 2 (1024 bit).
To Next Page
Loading...
