NETGEAR FVS318N - Page 259

Manage Users, Authentication, and VPN Certificates
259
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
4. In the Defined Addresses Status section of the screen, select one of the following radio
buttons:
• De
ny Login from Defined Addresses. Deny logging in from the IP addresses in the
Defined Addresses table.
• Al
low Login only from Defined Addresses. Allow logging in from the IP addresses
in the Defined Addresses table.
5. Click App
ly to save your settings.
6. In the Add
Defined Addresses section of the screen, add an address to the Defined
Addresses table by entering the settings as explained in the following table:
7. Click the Ad
d table button. The address is added to the Defined Addresses table.
8. Repe
at step 6 and step 7 for any other addresses that you want to add to the Defined
Addresses table.
 To delete one or more addresses:
1. I
n the Defined Addresses table, select the check box to the left of each address that you
want to delete, or click the Select All table button to select all addresses.
2. Click the Del
ete table button.
Configure Login Restrictions Based on Web Browser
 To restrict logging in based on the user’s browser:
1. Select Us
ers > Users. The Users screen displays (see Figure 149 on page 255).
2. In
the Action column of the List of Users table, click the Policies table button for the user for
which you want to set login policies. The policies submenu tabs display, with the Login
Policies screen in view.
3. Click the By C
lient Browser submenu tab. The By Client Browser screen displays. (The
following figure shows a browser in the Defined Browsers table as an example.)
Table 66. Defined addresses settings
Setting Description
Source Address Type Select the type of address fro
m the drop-down list:
• IP Ad
dress. A single IP address.
• IP Network. A subnet of IP addresses. You need to enter a netmask length in the
Mask Length field.
Network Address / IP
Ad
dress
Depending on your selection from the Source Address Type drop-down list, enter
the IP address or the network address.
Mask Length For a network address, enter the netmask length (0–32).
Note: By default, a single IP address is assigned a netmask length of 32.