• 2 wire cable of CBL2112A from connection IR of
SBC2100P. IR is a 5 pin connector located on the bottom
of SBC2100P.
4 After all above cables are removed, fully remove the front
panel assembly and set on a stable surface.
5 To reinstall, reverse above steps 2 and 3.
Note: Cable CBL2112A splits to two connectors: 5-pin connector
with 2 wires and 6-pin connector with 3 wires. Ensure the 3 wires
face outside when connecting the 6-pin connector on SBC2100P.
Note: There is a small hole adjacent to J9 on PCB2100A, which is
to polarize the connector.
Removal and Replacement of Main Board PCB2100A
Figure 4-4 Main Board PCB2100A
Refer to figure 4-4 and follow these steps:
1 Perform steps above for removal of Front Panel Assembly
DSP2102A.
2 Remove cable CBL2106A from J4 on PCB2100A.
3 Remove cable CBL2102A from P308 and CBL2125A from
P309 on PCB2100A.
4 Remove 4 screws and washers securing main board to
the main board support.
SECTION 4
Remove 4
screws and
washers
CBL2106
connected To
J4 on
PCB2100A
LCD cable
CBL2105A
Cables
CBL2112A to
SBC2100P
CBL2102A &
CBL2125A
connected to
P308 & P309
on PCB2100A
SER360 A1106 4-5
To Next Page
Loading...
