Removal and Replacement of Optical Encoder ENC1800P
1 Perform above steps for removal of the front panel cover
CVR2104M.
2 Using an 11mm wrench, remove the nut and washer securing
the encoder to the front panel cover CVR2104M.
3 To reinstall, reverse the above step 2.
Note: When securing the encoder with the nut and washer, tighten
the nut to 8 in/lbs of torque.
Removal and Replacement of Alarm LEDS
1 Perform above steps for removal the front panel cover
CVR2104M.
2 For each of the alarm LEDS, remove Qty 2 screws securing
the boards to the CVR2104M.
3 To reinstall, reverse above step 2.
Note: The red LED is p/n LED2101P and amber LED is p/n
LED2102P.
Removal and Replacement of LCD Display DSP2105P
Refer to figure 4-8 and 4-9 and follow these steps:
1 Perform above steps for removal of CBL2105A.
2 Remove the 4 nuts and washers securing the LCD housing
BKT2104M to the CVR2104M.
3 Remove the 4 screws securing the BKT2104M to the LCD
display DSP2105P.
4 T
o reinstall, reverse above steps 2 and 3.
SECTION 4
SER360 A1106 4-11
To Next Page
Loading...
