Newport e360 - 6. OPERATIONAL VERIFICATION PROCEDURE

6. OPERATIONAL VERIFICATION
PROCEDURE
Operational Verification Procedure...................... 6-1
Test Equipment................................................ 6-1
Setup .................................................................... 6-2
Electrical Safety Checks ...................................... 6-2
Ground Resistance test .................................. 6-2
Current Leakage test ...................................... 6-3
Operational Checks ............................................ 6-3
– Front Panel LED Check .............................. 6-4
– Circuit Leak Test .......................................... 6-5
– Loss of Gas Alarm........................................ 6-5
– F
I
O
2
Test ...................................................... 6-6
– Main Flow .................................................... 6-6
– Bias Flow .................................................... 6-8
– Inspiratory Time............................................ 6-8
– Respiratory Rate .......................................... 6-8
– Pressure Control .......................................... 6-9
– Pressure Support ........................................ 6-9
– Pressure Trigger Sensitivity ........................ 6-9
– PEEP/CPAP ................................................ 6-10
– Manual Inflation............................................ 6-11
– Inspiratory Tidal Volume .............................. 6-11
– Expiratory Tidal Volume .............................. 6-11
– Alarm Silence .............................................. 6-12
– Loss of Power Alarm and Battery
Operation...................................................... 6-12
e360 Operational Verification
Test Record Sheet .............................................. 6-13
SER360 A1106