Removal and Replacement of Touch Screen PNL2105P
Figure 4-10 Touch Screen Panel PNL2105P
Note:
Removal of the touch screen PNL2105P will destroy the
screen, do not remove unless you have a replacement touch
screen PNL2105P
.
Refer to figure 4-10 and follow these steps:
1 Perform above steps for removal of the LCD display
DSP2105P.
2 Using a flat screw driver
, pry the touch screen away from the
front bezel BZL2105M.
3 To install a new touch screen, clean all tape and adhesive from
the front bezel and wipe clean with isopropyl alcohol.
4 Apply 4 pieces of double side tape p/n
T
AP1200P around the
perimeter of the bezel. The tape should be placed 0.10” from
the inside edge. Press the tape firmly onto the bezel.
5 Peel back the protective cover on the double sided tape to
expose the adhesive, carefully place the new touch screen
PNL2105P on to the tape and press firmly.
6 Clean inside panel of debris and fingerprints before reinstalling
the LCD display PNL2105P
.
COMPONENT REMOVAL & REPLACEMENT
TAP1200P
BZL2105M
Affix tape 0.10” from the inside edge
4-12 SER360 A1106
To Next Page
Loading...
