Newport e360 - Software Upgrade Procedure

brittleness. If the tubing indicates any of those symptoms, replace
as necessary.
If tubing needs to be replaced, please contact Customer Service
and order the e360 Tube Replacement Kit.
Refer to the e360 System Pneumatic Diagram (SPD2100A)
located in Appendix C to cut each tube to length and replace the
worn tubing in the e360 ventilator.
Upon Completion
After overhaul is completed, perform a complete electronic and
pneumatic calibration as outlined in Section 5 of this manual and
the Operation Verification Procedure as provided in Section 6.
e360 SOFTWARE UPGRADE PROCEDURE
GENERAL INFORMATION
The following items are required for software upgrade:
• Latest Software on USB Flash Drive
• Software Upgrade Instructions
• NMI Reusable Patient Circuit (PBC340A) or equivalent
• Cap to plug end of patient circuit (CAP100P) or equivalent
Note: Follow this procedure to reload software after performing a
Main Board, Display Board or Single Board Computer component
replacement.
UPGRADE PROCEDURE
1 Confirm the e360 ventilator is OFF and connect
AC power
cord to the AC wall outlet (see Figure 2-13 for Power Entry
Module location).
2 Press and hold the “Accept” button and turn ON the power.
3 Release the “Accept” button when NMI Logo Screen is
displayed.
4 Wait for few minutes until the Software Download/Diagnostics
Mode screen is displayed, see Figure 2-11.
5 Connect USB Flash Drive (with latest software) to the USB
port on the Back Panel of the e360 ventilator (see Figure 2-13
for USB port location).
6 Press “Start Download” on touch screen (Figure 2-11). The
e360 ventilator will sound a short beep. “
Touch Selection to
Begin
” message on screen will change to a flashing message:
“
downloading…. ” Wait 15 – 20 minutes for software
download to complete.
SECTION 2
SER360 A1106 2-11