1 Perform steps above for removal of Main Board Support.
2 Remove the 4 pin ribbon cable from header H2 on the touch
screen interface board PCB2105P.
3 Remove cable CBL2112A from header H1 on the touch
screen interface board PCB2105P.
4 Remove Qty 9 screws and washers securing the PCB2102A
to the chassis of the DSP2102A.
5 Carefully lifting up on the display board from the lower left
corner near the encoder, locate and remove the cable of the
encoder from J209 on the PCB2102A.
6 Remove the lamp cable of LCD DSP2105P from JP203 on
PCB2102A.
7 Push on the tab and remove front panel membrane cable from
JP202 on PCB2102A.
8 Place the display board in an ESD safe container.
9 To reinstall, reverse above steps 2 through 7.
Note: If the Display Board PCB2102A is replaced, the e360
ventilator will need the software reloaded. Refer to Section 2 for
Software Upgrade Procedure.
Removal and Replacement of Touch Screen Interface Board PCB2105P
Refer to figure 4-7 above and follow these steps:
1 Perform steps above for removal of Display Board PCB2102A
2 Locate and remove 2 screws, washers and nuts securing the
PCB2105P to the display board.
3 To reinstall, reverse step 2.
COMPONENT REMOVAL & REPLACEMENT
4-8 SER360 A1106
To Next Page
Loading...
