Removal and Replacement of Large LCD Cable CBL2105A
Figure 4-8 CBL2105A
Refer to figure 4-8 and follow these steps:
1 Perform steps above to remove Display Board PCB2102A.
2 Using 7/32” nut driver, remove the nut securing the ground
wire of CBL2105A to the LCD housing BKT2104M
3 Using a 7/32” nut driver, remove the nut securing the cable
restraint for CBL2105A to the LCD housing BKT2104M
4 Gently lift the cable away from the LCD housing, releasing it
from the double sided tape.
5 Pull cable CBL2105A away from connector CN1 on the rear of
the LCD display.
6 To reinstall the CBL2105A, carefully align the cable connector
with CN1 on the LCD display and bend the cable up and push
the connector on to CN1 then press the connector on to the
double sided tape. Reverse above steps 2 and 3.
SECTION 4
LCD housing
BKT2104M
CBL2105A
4 nuts, 2 each side
securing LCD hous-
ing BKT2104M to
front panel cover
Double sided
tape located
under cable
Ground wire
and nut
Cable restraint
and nut
SER360 A1106 4-9
To Next Page
Loading...
