Removal and Replacement of Front Panel Cover CVR2104M
Figure 4-9 Front Panel Cover CVR2104M
Refer to figure 4-9 and follow these steps:
1 Perform above steps to remove the Display Board PCB2102A.
2 Using a 5/64” hex key, remove the set screw securing the
control knob to the encoder and remove the knob.
3 Remove Qty 8 screws and washers securing the CVR2104M
to the front panel bezel BZL2105M.
4 Remove the nut securing the flat ribbon cable ground to the
side of front panel cover CVR2104M.
5 Pull the front panel cover CVR2104M away from the front
bezel and place in an ESD safe container.
6 To reinstall, reverse above steps 2 through 5.
COMPONENT REMOVAL & REPLACEMENT
R
emove
8 screws
C
VR2104M
B
ZL2105M
N
ut securing flat ribbon
ground cable
Encoder knob
is located on
front of panel
4-10 SER360 A1106
To Next Page
Loading...
