Removal and Replacement of Sound Processor Board PCB2106P
Refer to figure 4-28 and follow these steps:
1 Perform above steps for removal of the battery.
2 Remove flat ribbon cable from CN1 on PCB2106P
3 Remove 2 screws and washers securing PCB2106P to the
e360 ventilator
4 Remove the board.
5 To reinstall, reverse above steps 2 through 4
Removal and Replacement of Single Board Computer SBC2100P
Figure 4-29 Single Board Computer SBC2100P
Refer to figure 4-29 and follow these steps:
1 Perform above steps for removal of battery.
2 Remove cables from the following locations:
Cable CBL2108A
to power connector
Cable CBL2112A
to
touch screen
connector
Cable CBL2105A
to LCD connector
Cable CBL2104A
to VGA connector
Cable CBL2114A
to USB connector
Cable CBL2112A to
touch screen
connector
COMPONENT REMOVAL & REPLACEMENT
Remove 4 screws
and washers, 1 in
each corner of
PCB2100P
4-28 SER360 A1106
To Next Page
Loading...
