Figure 4-13 Cover CRV2115M and Gasket GKT2101M
Refer to figures 4-11, 4-12 and 4-13 and follow these steps:
1 Perform steps above for Removal of Top Cover and Front
Panel Assembly.
2 Remove 6 screws securing the pneumatics cover CVR2106M.
3 Remove the 2 screws securing the cover CVR2115M and
gasket GKT2101M.
4 Remove the yellow tube and blue tube from the air and
oxygen inlet manifold BLK2115M
5 Remove the 4 screws securing the pneumatics panel
PNL2102M
6 Remove the yellow tube and blue tube from the air and
oxygen servo vales SVO2101P
7 While supporting the pneumatics panel, slide the panel away
from the e360 ventilator
.
8 T
o reinstall, support the pneumatics panel and align the air
and oxygen flow sensors into the flow sensor manifold block,
secure 2 screws on top for the pneumatics panel PNL2102M
before releasing support. Reverse steps 2 through 7.
COMPONENT REMOVAL & REPLACEMENT
Cover CRV2115M
with Gasket GKT2101M
4-14 SER360 A1106
To Next Page
Loading...
