7.1 Specification
7-4 ZM2376
• Measurement speed RAPid / FAST / MEDium / SLOW / VerySLOw
Typical measurement time
(Typical value. Time from input of trigger to output of measurement end
signal EOM)
Conditions: Measurement range hold, Trigger delay time = 0,
Averaging count = 1, Secondary parameter Rdc.
Signal acquisition time is the value subtracted by about 1ms from the above
value.
DUT can be replaced immediately after the completion of signal acquisition.
After replacement of DUT, the signal settling time is required additionally.
It should be an appropriate trigger delay time and not zero.
Additional time when measuring direct-current resistance Rdc
(supplementary value)
Conditions: DC resistance measurement range fixed, Trigger delay time = 0,
Averaging count = 1.
To Next Page
Loading...
