NF ZM2376 - Page 44

3.2 Display at Power “ON” and Initial Settings
3-10 ZM2376
Setting item
Parameter range
Initial value
INIT
*RST
Setting
memory
Resume
<Others>


Settling wait time during
automatic adjustment
1ms to 99ms
20ms
←
←


Operation mode
Mode 0|1
Mode 0
×
×
×

 Remarks
Initial value Set when device is shipped from factory, or when full initialization is executed with
the system setting menu.
INIT Set when initialization is executed with the initialize menu ( SHIFT + [INIT]).
*RST Set when *RST command of remote control is executed
← Same as left (initial values)
 Function provided. However, it is saved not in the setting memory but in the
correction value memory.
× Function not provided. (No influence)
 Function provided.
 Function provided. However, it is saved independently from general resume target
().
It cannot be set/query by the remote control.
The followings are out of the resume target:
• Measured data saved in the measured data buffer
• Latest measured data
• Range selected automatically
• Measurement parameters selected automatically
• Equivalent circuit selected automatically