NF ZM2376 - Page 61

3.5 Basic Operations
3-27 ZM2376
3.5.4 Initialization
There are two types of initialization as described below.
 Initialization of current settings
_SHIFT_ + [ INIT ]
Press the _SHIFT_ + [INIT] keys to display the initialize menu, and press the _1_ key, so that
currently used settings and correction values are reset to the default values.
Upon initialization, the initialization completion message “Done” is displayed, and then the
measurement screen comes back.
Done
The contents of the setting/correction value memory and the multi-measurement list are not
initialized.
If the EXIT operation is performed without pressing the _1_ key, the initialization is not
performed, and the measurement screen comes back.
Only the settings cannot be initialized without initializing correction values. Save necessary
correction values in the correction value memory.
_SHIFT_ _0_ | [INIT]
 Full initialization
To reset all settings except operation modes to the factory default values, perform full initialization.
The setting/correction value memory and the multi-measurement list are also initialized.
For details  “4.14 Initializing of All Settings”