Nikon D3100 VBA28001 - Shutter.pcb

VBA28001-R.3813.A
- D42 ・ D3100 -
OK NG: Not Good NG: Not Good
#1028
[Black]
[Red]
[Gray]
TA-0016 (5×8)
Shutter PCB
Turn the gear (indicated in red) of the SQ PCB unit in the direction of the arrow to raise the mirror.
Then, set the lever's position of the MG PCB unit to the "OK" position as below.
Caution: It may require turning the gear several times to become at "OK" position.
•
Peel off the tape [TA-0016 (5×8)] from the lens contact unit (#B2113).
Unsolder the three wires of the harness (#1028).
•
•
User ID:INC