Introduction 11Service Manual – Advenger, 2800ST, 3800ST, BR 755, BR 855
Towing the Machine
CAUTION!
The Drive Wheel (4) has a built in electromagnetic brake that is engaged whenever the Key Switch is Off or the Drive Pedal (3) is in the Neutral
position, i.e. there is no power to the Speed Control. This brake can be manually over ridden if necessary by inserting a medium to large
screwdriver behind the Yoke (A) as shown in FIGURE 3. (A rubber door stop can also be used). This should only be done in the event you need
to push or pull the machine.
Tow the machine for short distances only.
FIGURE 3
To Next Page
Loading...
