NIVELCO MultiCONT - APPENDIX 3. RELAY PROGRAMMING

prw2101a0600p_01  103 / 105
APPENDIX 3. RELAY PROGRAMMING
Not selected Selected
Select using button State of relay changes immediately after selection
Main menu
05
Devices Relays Current outs. Inputs UIM-s
config.
Default config. Restart MultiCONT Save config. Load config.
01: R1_IN 02: R12 : 12: R12n
Relays 18
:
Program Short
o
TAG
Inf
02
: R12 19
Source
ction
eter
Clear Update Fun Param Invert
TOT
TOT
Te s t
Program 20
:
1: SE300 2: SC380 : n: ST300-1
Source 21
:
No sign assigned Assigned with a "+" sign Assigned with a "–" sign Assigned to be averaged Modify using button
Hyst Alarm Alarm, K Window Window, D Error Pulse, F TOT Alt..S Sequential PV rate of change
Function 22
Not selected Selected Select using button
Param tere 23
RP1 = 0003.45 RP2 = 12.45 RP3 = 0
Parameter to be changed Selection of digit position Sign and number modification From RP1: exits to " " menu, from RP2 and RP3: steps back to the previous parameter
Programming
Accepts parameter change and moves on. Pressing when RP3 is highlighted: loads RP1..RP3 to the memory, and steps back to " " menu.
Programming
On Off
Invert 62
On Off Toggle
Test 42
Short TAG 25
R132-HCL
Info 74
Change using
buttons
Cancel
OK
Cycle: 2307 Working: 47 Input: 0.245 Output: OFF ID: 9729718162 Parent: 9729718172 Location: Internal
Active Not active (relay de-energised)
List number of relay
Relay ID Short TAG
Note: Relay cycle and worktime are saved every 6 mins.
PV SV TV QV
SE300
N
ot selected
Selected
Select using button Selected choice applies immediately