Nokia 7705 SAR-W Series User Manual

MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
135
----------------------------------------------
A:ALU-1>config>router>mpls# info
----------------------------------------------
frr-object
bypass-resignal-timer 120
hold-timer 3
resignal-timer 500
srlg-frr strict
----------------------------------------------
A:ALU-1>config>router>mpls# info
3.20.3 Configuring an MPLS Interface
The interface must exist in the system before it can be configured as an MPLS
interface; refer to the 7705 SAR Router Configuration Guide for more information.
Once the MPLS protocol instance is created, the no shutdown command is not
required since MPLS is administratively enabled upon creation. Configure the
label-map parameters if the interface is used in a static LSP.
Use the following CLI syntax to configure an MPLS interface on a router:
CLI Syntax: config>router>mpls
interface ip-int-name
admin-group group-name [group-name...(up to 5 max)]
label-map in-label
pop
swap out-label next-hop ip-address
no shutdown
srlg-group group-name [group-name...(up to 5 max)]
te-metric value
no shutdown
Example: config>router# mpls
config>router>mpls# interface to-104
config>router>mpls>if# label-map 35
config>router>mpls>if>label-map# swap 36 next-hop
10.10.10.91
config>router>mpls>if>label-map# no shutdown
config>router>mpls>if>label-map# exit
config>router>mpls>if# srlg-group “SRLG_fiber_1”
config>router>mpls>if# no shutdown
config>router>mpls# exit
The following example displays the interface configuration output.

Nokia 7705 SAR-W Series Specifications

General

Brand	Nokia
Model	7705 SAR-W Series
Category	Network Router
Language	English