Nokia 7705 SAR-W Series - PCEP Support for RSVP-TE LSPs

MPLS and RSVP-TE
88
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
3.11 PCEP Support for RSVP-TE LSPs
The Path Computation Element Communication Protocol (PCEP) is one of several
protocols used for communication between a wide area network (WAN) software-
defined network (SDN) controller and network elements.
The 7705 SAR operates as a PCE Client (PCC) only, supporting PCC capabilities for
RSVP-TE LSPs.
The following MPLS-level and LSP-level CLI commands are used to configure
RSVP-TE LSPs in a router acting as a PCC. See MPLS and RSVP-TE Command
Reference for command descriptions. See the PCEP Support for RSVP-TE LSPs
section in the PCEP chapter for information on using these commands.
• config>router>mpls>
pce-report rsvp-te {enable | disable}
• config>router>mpls>lsp>
path-profile profile-id [path-group group-id]
pce-computation
pce-control
pce-report {enable | disable | inherit}
• config>router>mpls>lsp-template>
pce-report {enable | disable | inherit}