Nokia 7705 SAR-W Series - SR-TE LSP Configuration Overview

MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
149
no shutdown
exit
interface "toSim213"
interface-type point-to-point
no shutdown
exit
interface "toSim219"
interface-type point-to-point
metric 2000
no shutdown
exit
exit
segment-routing
prefix-sid-range global
entropy-label {force-disable | enable}
no shutdown
exit
no shutdown
exit
Configure a segment routing tunnel MTU for the IGP instance, if required, by using
the tunnel-mtu command.
Example: prefix-sid-range global
tunnel-mtu 1500
no shutdown
Assign a node SID to each loopback interface that a router would use as the
destination of a segment routing tunnel by using the node-sid command.
Example: ospf 0
area 0.0.0.202
interface "system"
node-sid index 194
no shutdown
exit
3.23.2 SR-TE LSP Configuration Overview
An SR-TE LSP can be configured as an LSP using the existing CLI command
hierarchy under the MPLS context and specifying the sr-te LSP type.
CLI Syntax: config>router>mpls>lsp lsp-name | sr-te
A primary path can be configured for the SR-TE LSP.