Label Distribution Protocol
540
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
5.12.2.4 Monitor Commands
fec-egress-stats
Syntax fec-egress-stats ip-prefix/mask [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>ldp
Description This command displays egress statistics for LDP FEC prefixes at the configured interval until
the configured count is reached.
Monitor commands are similar to show commands, but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters ip-prefix[/mask] — the IP prefix and prefix length associated with the prefix FEC
Values
seconds — specifies the interval for each display, in seconds
Values 3 to 60
Default 10
repeat — specifies how many times the command is repeated
Values 1 to 999
Default 10
absolute — displays raw statistics, without processing. No calculations are performed
on the delta or rate statistics.
rate — displays the rate per second for each statistic instead of the delta
Output The following output is an example of statistics for an LDP FEC instance.
ipv4-prefix: a.b.c.d
ipv4-prefix-length: 32
ipv6-prefix: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0 to FFFF]H
d - [0 to 255]D
ipv6-prefix-length: 128
To Next Page
Loading...
Need help?
General
