MPLS and RSVP-TE
256
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
sr-te-lsp
Syntax sr-te-lsp [lsp-name] [status {up | down}] [detail] path [path-name]
sr-te-lsp [lsp-name] [detail]
sr-te-lsp [sp-name] [status {up | down}] [to ip-address] [detail]
Context show>router>mpls
Description This command displays segment routing-traffic engineering (SR-TE) LSP information.
Parameters lsp-name — displays SR-TE LSPs with the specified LSP name
status — displays SR-TE LSPs with the specified status (up or down)
detail — displays detailed information for the LSP template
path-name — displays SR-TE LSPs with the specified path name
ip-address — displays SR-TE LSPs connected to the IP address
Output The following outputs are examples of MPLS SR-TE path information.
• Output Example: SR-TE LSP
Table 18 Router MPLS Path Field Descriptions
Label Description
Path Name The unique name label for the LSP path
Adm Down — the path is administratively disabled
Up — the path is administratively enabled
Hop Index The value used to order the hops in a path
IP Address The IP address of the hop that the LSP should traverse on the
way to the egress router
Strict/Loose Strict — the LSP must take a direct path from the previous hop
router to the next router
Loose — the route taken by the LSP from the previous hop to
the next hop can traverse other routers
Opr The operational status of the path (up or down)
LSP Name The name of the LSP used in the path
Binding Primary — the preferred path for the LSP
Secondary — the standby path for the LSP
Paths Total number of paths configured
To Next Page
Loading...
Need help?
General
