Nokia 7705 SAR-W Series - Debug Commands

Label Distribution Protocol
548
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
5.12.2.5 Debug Commands
The following output shows debug LDP configurations discussed in this section.
ALU-12# debug router ldp peer 10.10.10.104
ALU-12>debug>router>ldp# show debug ldp
debug
router "Base"
ldp peer 10.10.10.104
event
bindings
messages
exit
packet
hello
init
keepalive
label
exit
exit
exit
exit
ALU-12>debug>router>ldp#
ldp
Syntax [no] ldp
Context debug>router
Description This command configures LDP debugging.
interface
Syntax [no] interface interface-name
Context debug>router>ldp
Description This command configures debugging for a specific LDP interface.
Parameters interface-name — specifies an existing interface
peer
Syntax [no] peer ip-address
Context debug>router>ldp
Description This command configures debugging for a specific LDP peer.