Label Distribution Protocol
422
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
5.4.10.1 Configuration at mirror source node
Use the following rules and syntax to configure a spoke SDP at the mirror source
node.
• The sdp-id must match an SDP that uses an LDP IPv6 FEC.
• Configuring the egress-vc-label is optional.
CLI Syntax: no spoke-sdp sdp-id:vc-id
spoke-sdp sdp-id:vc-id [create] egress
vc-label egress-vc-label
5.4.10.2 Configuration at mirror destination node
Use the following rules and syntax to configure mirror service at the mirror
destination node.
• The far-end ip-address command is not supported with LDP IPv6 transport
tunnel. The user must reference a spoke SDP using an LDP IPv6 SDP coming
from mirror source node.
• In the spoke-sdp sdp-id:vc-id command, the vc-id should match that of the
spoke-sdp configured in the mirror-destination context at the mirror source
node.
• Configuring the ingress-vc-label is optional; both Static and T-LDP are
supported.
CLI Syntax: far-end ip-address [vc-id vc-id] [ing-svc-label ingress-
vc-label | tldp] [icb]
no far-end ip-address
spoke-sdp sdp-id:vc-id [create] ingress-vc-label
ingress-vc-label exit
no shutdown exit
exit
Mirroring is also supported with the PW redundancy feature when the endpoint spoke
SDP, including the ICB, is using an LDP IPv6 tunnel.
To Next Page
Loading...
Need help?
General
