MPLS and RSVP-TE
166
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
3.24.2.1.1 Generic Commands
shutdown
Syntax [no] shutdown
Context config>router>mpls
config>router>mpls>ingress-statistics>lsp
config>router>mpls>interface
config>router>mpls>if>label-map
config>router>mpls>lsp>egress-statistics
config>router>mpls>path
config>router>mpls>static-lsp
Description The shutdown command administratively disables an entity. The operational state of the
entity is disabled as well as the operational state of any entities contained within. When
disabled, an entity does not change, reset, or remove any configuration settings or statistics.
Many objects must be shut down before they can be deleted. Many entities must be explicitly
enabled using the no shutdown command.
In the label-map context, all packets that match the specified in-label are dropped when the
label map is shut down.
In the path context, this command disables the existing LSPs using this path. All services
using these LSPs are affected. Binding information, however, is retained in those LSPs.
Paths are created in the shutdown state.
The no form of this command places the entity into an administratively enabled state. In the
mpls and mpls>interface contexts, this triggers any LSPs that were previously defined
under the associated context to come back up. In the path context, the no form of this
command administratively enables the path and all LSPs—where the path is defined as a
primary or a standby secondary path—are (re)established.
Default mpls — no shutdown
interface — shutdown
label-map — no shutdown
path — shutdown
static-lsp — shutdown
To Next Page
Loading...
Need help?
General
