MPLS and RSVP-TE
172
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
hold-timer
Syntax hold-timer seconds
no hold-timer
Context config>router>mpls
Description This command specifies the amount of time that the ingress node waits before programming
its data plane and declaring to the service module that the LSP status is up.
The no form of the command disables the hold-timer.
Parameters seconds — specifies the hold time, in seconds
Values 0 to 10
least-fill-min-thd
Syntax least-fill-min-thd percent
no least-fill-min-thd
Context config>router>mpls
Description This parameter is used in the least-fill path selection process. See the description of the
least-fill command for information on the least-fill path selection process. When comparing
the percentages of least available link bandwidth across the available paths, whenever two
percentages differ by less than the value configured as the least-fill minimum threshold,
CSPF considers them to be equal and applies a random number generator to select the path.
The no form of the command resets this parameter to its default value.
Default 5
Parameters percent — specifies the least fill minimum threshold value as a percentage
Values 1 to 100
least-fill-reoptim-thd
Syntax least-fill-reoptim-thd percent
no least-fill-reoptim-thd
Context config>router>mpls
Description This parameter is used in the least-fill path selection process. See the description of the
least-fill command for information on the least-fill path selection process.
To Next Page
Loading...
Need help?
General
