MPLS and RSVP-TE
178
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
An accounting policy must first be configured in the config>log>accounting-policy context
before it can be associated; otherwise an error message is generated.
The no form of this command removes the accounting policy association.
Default no accounting-policy
Parameters policy-id — the accounting policy ID
Values 1 to 99
collect-stats
Syntax [no] collect-stats
Context config>router>mpls>ingr-stats>lsp
config>router>mpls>lsp>egress-statistics
Description This command enables accounting and statistical data collection.
The collected statistic counters can be retrieved via show and monitor commands or with
the SNMPv3 interface. The counters can be saved to an accounting file if the specific
statistics collection record is included in the default accounting policy or in a user-defined
accounting policy.
If the no collect-stats command is issued, the statistics are still accumulated by the
forwarding engine. However, the CPU will not obtain the results and write them to the
accounting file. If a subsequent collect-stats command is issued, then the counters written
to the accounting file will include all the traffic that went through while the no collect-stats
command was in effect.
Default no collect-stats
egress-statistics
Syntax [no] egress-statistics
Context config>router>mpls>lsp
Description This command configures statistics in the egress data path of an originating LSP at a
head-end node. The user must also execute the no shutdown command in this context to
enable statistics collection.
The no form of this command disables the statistics in the egress data path and removes the
accounting policy association from the RSVP LSP.
Default no egress-statistics
To Next Page
Loading...
Need help?
General
