MPLS and RSVP-TE
182
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
3.24.2.1.5 Interface Label-Map Commands
label-map
Syntax [no] label-map in-label
Context config>router>mpls>interface
Description This command is used on either transit or egress LSP routers when a static LSP is defined.
The static LSP on the ingress router is initiated using the config>router>mpls>static-lsp
lsp-name command. The in-label is associated with a pop action or a swap action, but not
both. If both actions are specified, the last action specified takes effect.
The no form of this command deletes the static LSP configuration associated with the
in-label.
Parameters in-label — specifies the incoming MPLS label on which to match
Values 32 to 1023
pop
Syntax [no] pop
Context config>router>mpls>if>label-map
Description This command specifies that the incoming label must be popped (removed). No label
stacking is supported for a static LSP. The service header follows the top label. Once the label
is popped, the packet is forwarded based on the service header.
The no form of this command removes the pop action for the in-label.
Default n/a
swap
Syntax swap out-label nexthop ip-address
no swap
Context config>router>mpls>if>label-map
Description This command swaps the incoming label and specifies the outgoing label and next-hop IP
address on an LSR for a static LSP.
The no form of this command removes the swap action associated with the in-label.
Default n/a
To Next Page
Loading...
Need help?
General
