MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
187
The system generates an SNMP trap if BFD fails on an LSP, regardless of whether a failure
action is configured.
The no form of the command removes the configuration.
Default no failure-action
Parameters failover-or-down — the active path of an SR-TE LSP switches to the secondary or next-
preferred available secondary path, or the LSP goes operationally down if no other
path is available
wait-for-up-timer
Syntax wait-for-up-timer seconds
no wait-for-up-timer
Context config>router>mpls>lsp>bfd
config>router>mpls>lsp>primary>bfd
config>router>mpls>lsp>secondary>bfd
Description This command configures the time to wait for BFD to come up on a path. This timer applies
to SR-TE LSPs. The timer is started when BFD is first enabled on a path or BFD transitions
from up to down. If the timer expires before BFD comes up, the path is torn down and the
retry timer is started.
The wait-for-up-timer command is only available if the configured failure action is failover-
or-down.
The no form of the command resets the timer to the default value.
Default 4
Parameters seconds — the time to wait for BFD to come up
Values 0 to 60
bgp-transport-tunnel
Syntax bgp-transport-tunnel {include | exclude}
Context config>router>mpls>lsp
config>router>mpls>lsp-template
Description This command allows an RSVP-TE LSP to be used as a transport LSP for BGP tunnel routes
or blocks it from being used.
Default include
To Next Page
Loading...
