MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
199
metric
Syntax metric metric
Context config>router>mpls>lsp
config>router>mpls>lsp-template
Description This command specifies the metric for this LSP, which is used to select an LSP from among
a set of LSPs that are destined for the same egress router. The LSP with the lowest metric
will be selected.
The operational metric for an LSP that uses the TE metric in CSPF path calculations can be
overridden by the configured administrative LSP metric parameter.
Default 1
Parameters metric — specifies the metric for this LSP
Values 1 to 16777215
path-profile
Syntax path-profile profile-id [path-group group-id]
no path-profile profile-id
Context config>router>mpls>lsp
Description This command configures the PCE path profile and path group ID.
The PCE supports the computation of disjoint paths for two different LSPs originating or
terminating on the same or different PE routers. In order to indicate this constraint to the PCE,
the user must configure the PCE path profile ID and path group ID that the PCE-computed or
PCE-controlled LSP belongs to. These parameters are passed transparently by the PCC to
the PCE and are thus opaque data to the router.
The association of the optional path group ID is to allow the PCE to determine which profile
ID this path group ID must be used with. One path group ID is allowed per profile ID. The user
can, however, enter the same path group ID with multiple profile IDs by executing this
command multiple times. A maximum of five entries of path-profile [path-group] can be
associated with the same LSP.
Parameters profile-id — specifies the profile ID
Values 1 to 4294967295
group-id — specifies the path group ID
Values 0 to 4294967295
To Next Page
Loading...
