MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
203
retry-timer
Syntax retry-timer seconds
no retry-timer
Context config>router>mpls>lsp
config>router>mpls>lsp-template
Description This command configures the time, in seconds, between LSP re-establishment attempts after
the LSP has failed.
The no form of this command reverts to the default value.
Default 30
Parameters seconds — specifies the amount of time, in seconds, between attempts to re-establish
the LSP after it has failed
Values 1 to 600
rsvp-resv-style
Syntax rsvp-resv-style [se | ff]
Context config>router>mpls>lsp
Description This command specifies the RSVP-TE reservation style, shared explicit (se) or fixed filter (ff).
A reservation style is a set of control options that specify a number of supported parameters.
The style information is part of the LSP configuration.
Default se
Parameters ff — fixed filter is single reservation with an explicit scope. This reservation style
specifies an explicit list of senders and a distinct reservation for each of them. A
specific reservation request is created for data packets from a particular sender. The
reservation scope is determined by an explicit list of senders.
se — shared explicit is shared reservation with a limited scope. This reservation style
specifies a shared reservation environment with an explicit reservation scope. This
reservation style creates a single reservation over a link that is shared by an explicit
list of senders. Because each sender is explicitly listed in the RESV message,
different labels can be assigned to different sender-receiver pairs, thereby creating
separate LSPs.
shutdown
Syntax [no] shutdown
Context config>router>mpls>lsp
To Next Page
Loading...
