MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
207
The no form of this command removes the association between this path-name and lsp-
name. All specific configurations for this association are deleted. The secondary path must
be shut down first in order to delete it. The no secondary path-name command will not result
in any action except a warning message on the console indicating that the secondary path is
administratively up.
Default n/a
Parameters path-name — specifies the case-sensitive alphanumeric name label for the LSP path, up
to 32 characters in length
adaptive
Syntax [no] adaptive
Context config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description This command enables the make-before-break (MBB) functionality for an LSP or a primary
or secondary LSP path. When enabled for the LSP, a make-before-break operation will be
performed for the primary path and all the secondary paths of the LSP.
Default adaptive
bandwidth
Syntax bandwidth rate-in-mbps
no bandwidth
Context config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description This command specifies the amount of bandwidth to be reserved for the LSP path.
The no form of this command resets bandwidth parameters (no bandwidth is reserved).
Default no bandwidth — bandwidth setting in the global LSP configuration
Parameters rate-in-mbps — specifies the amount of bandwidth reserved for the LSP path in Mb/s
Values 0 to 100000