MPLS Guide MPLS and RSVP-TE
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
219
3.24.2.2.2 RSVP-TE Global Commands
rsvp
Syntax [no] rsvp
Context config>router
Description This command creates the RSVP-TE protocol instance and enables RSVP-TE configuration.
RSVP-TE is enabled by default.
RSVP-TE is used to set up LSPs. RSVP-TE should be enabled on all router interfaces that
participate in signaled LSPs.
The no form of this command deletes this RSVP-TE protocol instance and removes all
configuration parameters for this RSVP-TE instance. To suspend the execution and maintain
the existing configuration, use the shutdown command. RSVP-TE must be shut down before
the RSVP-TE instance can be deleted. If RSVP-TE is not shut down, the no rsvp command
does nothing except issue a warning message on the console indicating that RSVP-TE is still
administratively enabled.
Default no shutdown
entropy-label-capability
Syntax [no] entropy-label-capability
Context config>router>rsvp
Description This command enables or disables the entropy label capability for an RSVP-TE LSP. When
enabled, the egress LER (eLER) signals to the ingress LER (iLER) that the LSP is capable
of using entropy labels.
The no form of the command disables entropy label capability.
Default no entropy-label-capability
graceful-shutdown
Syntax [no] graceful-shutdown
Context config>router>rsvp
config>router>rsvp>interface
To Next Page
Loading...
Need help?
General
