MPLS and RSVP-TE
288
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
lsp-ingress-stats
Syntax lsp-ingress-stats [ip-address lsp lsp-name]
Context clear>router>mpls
Description This command clears RSVP LSP ingress statistics.
Parameters ip-address — the system IP address of the sender (a.b.c.d)
lsp-name — the name that identifies the LSP
interface
Syntax interface [ip-int-name] [statistics]
Context clear>router>rsvp
Description This command resets or clears statistics for an RSVP-TE interface.
Parameters ip-int-name — identifies the IP interface to clear. The interface name cannot be in the
form of an IP address. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double
quotes
statistics — clears only statistics
statistics
Syntax statistics
Context clear>router>rsvp
Description This command clears global statistics for the RSVP-TE instance; for example, clears path
and resv timeout counters.
Note: When RSVP LSP statistics are cleared, the current aggregate statistics count is
recorded as a baseline and is used to provide a relative count each time the statistics are
viewed with the show command. Because this baseline number is not reconciled between
the active and inactive CSMs, after a CSM activity switch the statistics on the newly active
CSM will show the aggregate count as though no clear command has been executed.
To Next Page
Loading...
