PCEP
360
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
lsp-db
Syntax lsp-db [lsp-type lsp-type] [delegated-pce ip-address]
lsp-db [lsp-type lsp-type] from ip-address [delegated-pce ip-address]
lsp-db [lsp-type lsp-type] lsp lsp-name [delegated-pce ip-address]
lsp-db [lsp-type lsp-type] to ip-address [tunnel-id [tunnel-id]]
lsp-db [lsp-type lsp-type] tunnel-id [tunnel-id]
Context show>router>pcep>pcc
Description This command displays PCEP PCC LSP information.
Parameters lsp-type — specifies the type of LSP to display. The only available option is RSVP-TE
point-to-point LSPs (rsvp-p2p).
tunnel-id — specifies a tunnel ID
Values 0 to 65535
ip-address — specifies an IPv4 address
Values a.b.c.d
Output The following output is an example of PCEP PCC LSP information.
Capabilities List The capabilities list for the PCEP session
Address The local IP address of the PCEP speaker
Report Path Constraints Indicates whether to include LSP path constraints in the
PCE report messages sent from the PCC to a PCE
Open Wait Timer The value of the open wait timer for the PCEP session
Keep Wait Timer The value of the keep wait timer for the PCEP session
Sync Timer The value of the synchronization timer for the PCEP
session
Request Timer The value of the request timer for the PCEP session
Connection Timer The value of the keep wait timer for the PCEP session
Allow Negotiations Indicates where negotiations between PCEP PCC
and
PCE are allowed
Max Sessions The maximum number of PCEP sessions on the router
Max Unknown Req The maximum number of unknown requests for PCEP
sessions on the router
Table 36 PCEP PCC Field Descriptions (Continued)
Label Description
To Next Page
Loading...
Need help?
General
