MPLS Guide Label Distribution Protocol
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
473
When the interface option is selected, the transport connection (TCP) for the link LDP
session configured by the transport-address command is automatically set to interface.
Having both the local-lsr-id and transport address set to the local interface creates two TCP
sessions to the peer and therefore two different LDP label spaces: one to the interface IP
address for link LDP (L-LDP) and one to the system IP address for T-LDP.
The no form of the command resets the local-lsr-id to the default value.
Default system
Parameters system — specifies that the system IP address is used to set up the LDP session
between peers
interface — specifies that the IP interface address is used to set up the LDP session
between peers
p2mp-ipv4
Syntax p2mp-ipv4 {enable | disable}
Context config>router>ldp>session-params>if>ipv4>fec-type-capability
config>router>ldp>session-params>if>ipv6>fec-type-capability
Description This command enables or disables IPv4 P2MP FEC capability on the interface.
Default p2mp disable
Parameters enable | disable — enables or disables IPv4 P2MP FEC capability
p2mp-ipv6
Syntax p2mp-ipv6 {enable | disable}
Context config>router>ldp>session-params>if>ipv4>fec-type-capability
config>router>ldp>session-params>if>ipv6>fec-type-capability
Description This command enables or disables IPv6 P2MP FEC capability on the interface.
Default p2mp disable
Parameters enable | disable — enables or disables IPv6 P2MP FEC capability
To Next Page
Loading...
