MPLS Guide Label Distribution Protocol
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
481
The no form of the command resets the local-lsr-id to the default value, which means that
the system interface address is used as the LSR ID.
Default no local-lsr-id
Parameters interface-name — specifies the name, up to 32 characters in length, of the network IP
interface. An interface name cannot be in the form of an IP address. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed
within double quotes.
tunneling
Syntax [no] tunneling
Context config>router>ldp>targeted-session>peer
Description This command enables LDP over tunnels.
The no form of the command disables tunneling.
Default no tunneling
lsp
Syntax [no] lsp lsp-name
Context config>router>ldp>targeted-session>peer>tunneling
Description This command configures an LSP destined for this peer to be used for tunneling an LDP FEC
over RSVP-TE. A maximum of four RSVP-TE LSPs can be used for tunneling LDP FECs to
the T-LDP peer.
It is not necessary to specify any RSVP-TE LSP in this context unless there is a need to
restrict the tunneling to selected LSPs. All RSVP-TE LSPs with a to address matching that of
the T-LDP peer are eligible by default. The user can also exclude specific LSP names by
using the ldp-over-rsvp exclude command in the config>router>mpls>lsp lsp-name
context.
The no form of this command removes the LSP association.
Parameters lsp-name — specifies the name of the LSP
To Next Page
Loading...
