MPLS Guide Label Distribution Protocol
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
489
Tunneling : Disabled
Lsp Name : None
===============================================================================
A:ALU-12>show>router>ldp#
Table 45 LDP Interface Field Descriptions
Label Description
Interface The interface associated with the LDP instance
Adm Up — indicates that the LDP is administratively enabled
Down — indicates that the LDP is administratively disabled
Opr Up — indicates that the LDP is operationally enabled
Down — indicates that the LDP is operationally disabled
Hello Fctr The value by which the hello timeout should be divided to give the
hello time; that is, the time interval, in seconds, between LDP
Hello messages. LDP uses hello messages to discover
neighbors and to detect loss of connectivity with its neighbors.
Hold Time The time interval, in seconds, that LDP waits before declaring a
neighbor to be down. Hold time (also known as Hello time) is
local to the system and is sent in the hello messages to a
neighbor.
KA Fctr The value by which the keepalive timeout should be divided to
give the keepalive time; that is, the time interval, in seconds,
between LDP keepalive messages. LDP keepalive messages
are sent to keep the LDP session from timing out when no other
LDP traffic is being sent between the neighbors.
KA Time The time interval, in seconds, that LDP waits before tearing down
a session. If no LDP messages are exchanged during this time
interval, the LDP session is torn down. Generally the value is
configured to be three times the keepalive time (the time interval
between successive LDP keepalive messages).
Transport Address The transport address entity
No. of Interfaces The total number of LDP interfaces
Oper Down Reason The reason for the LSP being in the down state
Active Adjacencies The number of active adjacencies
Last Modified The time of the last modification to the LDP interface
Lsp Name The LSP name
To Next Page
Loading...
Need help?
General
