MPLS Guide Label Distribution Protocol
3HE 18686 AAAB TQZZA © 2022 Nokia.
Use subject to Terms available at: www.nokia.com
493
session
Syntax session [ip-addr [:label-space]] local-addresses [sent | recv] ip-addr ip-address
session [ip-addr [:label-space]] [session-type] [state state] [detail | summary]
session [ip-addr [:label-space]] local-addresses [sent | recv] [family]
session [ip-addr [:label-space]] statistics [packet-type] [session-type]
session statistics [packet-type] [session-type] [family]
session [session-type] [state state] [detail | summary] [family]
Context show>router>ldp
Description This command displays configuration information about LDP sessi
ons.
Parameters ip-addr — specifies the IP address of the LDP peer
label-space — specifies the label space identifier that the router is advertising on the
interface
Values 0 to 65535
detail — displays detailed information
summary — displays summary information
ip-address — specifies the IP address
state — specifies the current operational state of the adjacency
Values established, trying, down
packet-type — specifies the packet type
Values hello, keepalive, init, label, notification, address
Hello Factor The value by which the hello timeout should be divided to give the
hello time; that is, the time interval, in seconds, between LDP
Hello messages. LDP uses hello messages to discover neighbors
and to detect loss of connectivity with its neighbors.
Disable — indicates that no authentication is being used
Passive Mode True — indicates that LDP responds only when it gets a connect
request from a peer and will not attempt to actively connect to its
neighbors
False — indicates that LDP actively tries to connect to its peers
Targeted Sessions Enabled — indicates that targeted sessions are enabled
Disabled — indicates that targeted sessions are disabled
Table 46 LDP Parameters Field Descriptions (Continued)
Label Description
To Next Page
Loading...
