Label Distribution Protocol
510
MPLS Guide
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 18686 AAAB TQZZA
Context show>router>ldp>bindings
Description This command displays information about LDP active bindings.
Parameters detail — displays detailed information
summary — displays information in a summarized format
family — displays either IPv4 or IPv6 active LDP information
Values ipv4 or ipv6
egress-if port-id — displays LDP active bindings by matching egress-if
Values slot[/mda[/port]] or slot/mda/port[.channel]
aps-id : aps-group-id[.channel]
group-id : 1 to 24]
mw-link-id : mw-link-link-num
link-num : 1 to 24
egress-lsp tunnel-id — displays LDP active bindings by matching on the egress RSVP-
TE LSP tunnel-id for LDP FECs that are tunneled over an RSVP-TE LSP. The tunnel-
id for the RSVP-TE LSP can be found in the output of the show router mpls lsp
detail command and in the show router tunnel-table command. It is not the
Path LSP ID shown in the output of the show router mpls lsp path detail
command.
Values 0 to 4294967295
egress-nh ip-address — displays LDP active bindings by matching egress-nh
Values
opaque-type opaque-type — specifies the type of a multipoint opaque value element
Values generic, ssm, vpn-ssm, recursive-ssm, vpn-recursive, grt-recursive
inner-root ip-address — displays recursive FECs whose inner root address matches the
specified address
innermost-root ip-address — displays recursive FECs whose inner root address
matches the specified address and non-recursive FECs that have a root address that
matches the specified address
ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0 to FFFF]H
d - [0 to 255]D
To Next Page
Loading...
