Appliance Overview
Nokia IP40 Security Platform User’s Guide v1.1 31
Note
Do not use a sharp pin or thin piece of metal to press the Reset button.
Console The console port is a 9-pin male connector that can be
connected to the serial (COM) port of your computer.
You can then use the command-line interface (CLI) of
the IP40 through a serial program such as
HyperTerminal to communicate with the device.
Reset Used to reboot or reset the IP40 to its factory defaults.
Use a large flat-tipped object, such as a thick paper
clip, to press the reset button.
Short press (one second): reboots the Nokia IP40
Security Platform.
Long press (seven seconds): resets the IP40 to its
factory defaults. This results in loss of all security
services and passwords.
Short press during boot up: boots the IP40 in special
deployment mode. See “Resetting Nokia IP40 Security
Platform to Factory Defaults by Using the Reset
Button” on page 151.
Table 9 explains the items on the rear panel of the Nokia IP40.
Table 9 Rear Panel of IP40
Label Description
To Next Page
Loading...
