NORD MODULAR G2 V1.1 11. Module reference: The Oscillator group
Page 135
the Level settings also affect the Rates. The greater the difference between two adjacent Level settings,
the longer it will take to “travel” between the Levels. If two adjacent Level settings are the same, the
Rate value between these levels is of no importance.
AM
AMAM
AM
O
OO
OD
DD
D
This is the function for modulating the amplitude with a bipolar control signal. Patch a control signal to
the AMod input and set the sensitivity with the arrow buttons. Range 0-7 where 7 is the highest sensitiv-
ity.
V
VV
V
E
EE
EL
LL
L
I
II
IN
NN
NP
PP
PU
UU
UT
TT
T
Here you control the levels of the level & rate envelope generator. The velocity sensitivity is set with the
Vel arrow buttons as described above. Note that lower envelope levels means that the entire envelope cy-
cle becomes faster!
B
BB
B
R
RR
R
P
PP
P
O
OO
OI
II
IN
NN
NT
TT
T
Set the break point note number for the Keyboard Level Scaler. The value is displayed in the correspond-
ing display box. Range: A-1 to C8.
-L
-L-L
-L
I
II
IN
NN
N
/-E
/-E/-E
/-E
X
XX
XP
PP
P
/+E
/+E/+E
/+E
X
XX
XP
PP
P
/+L
/+L/+L
/+L
I
II
IN
NN
N
Click to select Linear or Exponential attenuation or amplification characteristics of the level scaling.
L-D
L-DL-D
L-D
E
EE
EP
PP
PT
TT
TH
HH
H
Set the amplification/attenuation slope for the lower key section with the arrow buttons. The value is dis-
played in the corresponding display box.
R-D
R-DR-D
R-D
E
EE
EP
PP
PT
TT
TH
HH
H
Set the amplification/attenuation slope for the upper key section with the arrow buttons. The value is
displayed in the corresponding display box.
G
GG
GR
RR
RA
AA
AP
PP
PH
HH
H
Displays the two gain slopes and the break point graphically. The Y-axis represents the output level and
the X-axis the entire note range (A-1 to C8). the horizontal line represents the 0 dB output level.
To Next Page
Loading...
Need help?
General